I have a HP HP DV2000 - Specific Model is DV2222TX and here's what I got so far:

System Specs:
Intel Core 2 Duo T2250 1.73 Ghz, NVideo Go7200, Connextant Audio, Webcam, Intel Pro 100ve, Intel 3945 Wireless, Bluetooth, Matshita DVD ram UJ-8515 (Dual Layer DVDRW), 2 Gb ram, 320 GB HD

Distro: iDeneb 10.5.7
Kernel: Darwin kernel 9.7.0
Bootloader: Chameleon 1.0.12

Working so far:

* Audio (ootb) Connexant High Definition Audio (Working with VoodooHDA) ***See Updated Post below
* Video (NVKrush for Quartz Extreme Support and 1280x800x32bit)
* Wired Lan: Intel Pro 100ve ( ootb)
* Bluetooth (ootb)
* Webcam (ootb)
* Audio Out (ootb)
* USB (ootb)
* Keyboard and Trackpad (ootb)
* Wireless --- Intel 3945 --forget about it! Swapped for BCM 94311 HP White listed *Phew
* Quartz GL ( Only working with NVCrush)

Not working:
* Sleep ( Works but audio is choppy after wake)
* mic ( built in, untested ext mic - who cares get USB headset for skype)

iDeneb selections:

* Chameleon 1.0.12
* 9.7.0 kernel
* AppleDecrypt
* Disabler
* DSDT Patcher
* TimeMachine Fix
* openhaltreset fix
* Seatbelt fix
* idlehaltfix
* Voodoo HDA ( Someone said AppleAzzliaAudio would be a better choice)
* ICHx fixed
* Intel100ProVE
* Broadcom Wifi
* Voodoo Power battery
* Intel Power Management
* Nvidia NVInject 0.2.1 (Repleace with NVkrush after install)


Notes:
1- Add -f to com.apple.Boot.plist for kernel flag to fix wired ethernet dropping off.
2- Replaced NVinject with NVKrush as Quartz would not enable with nvinject no way no how and damnit I need quartz with this crappy nvidia go card.
3 - had to reapply a seatbelt fix for kernel 9.7.0 as it was panic city on dmg downloads with safari.

todo:

need to test AppleAzzilla kext as a replacement for VoodooHDA to see if it cures sleep to wake sound stutter issues.

Conculsion:

Didn't think I would get this one done as well .. its a flippin HP but it's a nice little hackintop now aside from the missing 1%. If anyone has any suggestions or comments and or questions be happy to accept them.

**** Replaced VoodooHDA with AppleAzaliaAudio and fixed stuttering sound issue after wake from sleep. However mic in still not working and now no ext audio out. I think this is a good trade off though as sleep is very important and I can always use a USB headset if needed.

Platform

Core

Model Identifier: HP Pavilion dv2500 Notebook PC
Processor Name: Intel® Core(TM)2 Duo CPU T7500 @
Processor Speed: 2.2 GHz
Total Number Of Cores: 2
L2 Cache (per processor): 4 MB
CPU Features: FPU VME DE PSE TSC MSR PAE MCE CX8 APIC SEP MTRR PGE MCA CMOV PAT PSE36 CLFSH DS ACPI MMX FXSR SSE SSE2 SS HTT TM SSE3 MON DSCPL VMX EST TM2 SSSE3 CX16 TPR PDCM
Memory: 2 GB
Bus Speed: 2.67 GHz
Boot ROM Version: MP31.88Z.006C.B05.0802291410 (Apple Inc.)

ATA:

ATA Bus:

Slimtype DVD A DS8A1P:

Model: Slimtype DVD A DS8A1P
Revision: CH71
Detachable Drive: No
Protocol: ATAPI
Unit Number: 0
Socket Type: Internal
Low Power Polling: No
Power Off: No

Audio (Built In):

Intel High Definition Audio:

Device ID: 0x103C30CD

Bluetooth:

Apple Bluetooth Software Version: 2.1.6f8
Hardware Settings:
Manufacturer: Broadcom
Firmware Version: 207 (8489)
Bluetooth Power: On
Requires Authentication: No

Disc Burning:

Slimtype DVD A DS8A1P:

Firmware Revision: CH71
Interconnect: ATAPI
Burn Support: Yes (Generic Drive Support)
Profile Path: None
Cache: 2048 KB
Reads DVD: Yes
CD-Write: -R, -RW
DVD-Write: -R, -R DL, -RAM, -RW, +R, +R DL, +RW
Write Strategies: CD-TAO, CD-SAO, CD-Raw, DVD-DAO
Media: Insert media and refresh to show available burn speeds

Graphics/Displays:

Intel GMA X3100:

Chipset Model: GMA X3100
Type: Display
Bus: Built-In
VRAM (Total): 144 MB
Vendor: Intel (0x8086)
Device ID: 0x2a02
Revision ID: 0x000c
Displays:
Display:
Resolution: 1280 x 800
Depth: 32-Bit Color
Core Image: Hardware Accelerated
Main Display: Yes
Mirror: Off
Online: Yes
Quartz Extreme: Supported
Built-In: Yes
Display Connector:
Status: No Display Connected

Memory:

Bank 0/M1:

Size: 1 GB
Type: DDR2 SDRAM
Speed: 667 MHz
Status: OK

Bank 1/M2:

Size: 1 GB
Type: DDR2 SDRAM
Speed: 667 MHz
Status: OK

Power:

Battery Information:

Model Information:
Manufacturer: DP-SAN44
Device name: VE06047
Charge Information:
Charge below critical level: No
Charge below warning level: No
Charge remaining (mAh): 603
Fully charged: Yes
Charging: No
Full charge capacity (mAh): 603
Health Information:
Cycle count: 6
Condition: Check Battery
Battery Installed: Yes
Amperage (mA): 3601
Voltage (mV): 12344

Serial-ATA:

Intel ICH8-M AHCI:

Vendor: Intel
Product: ICH8-M AHCI
Speed: 3 Gigabit
Description: AHCI Version 1.10 Supported

USB:

USB High-Speed Bus:

Host Controller Location: Built In USB
Host Controller Driver: AppleUSBEHCI
PCI Device ID: 0x2836
PCI Revision ID: 0x0003
PCI Vendor ID: 0x8086
Bus Number: 0xfd

HP Webcam:

Product ID: 0xb016
Vendor ID: 0x04f2 (Chicony Electronics Co., Ltd.)
Version: 6.04
Speed: Up to 480 Mb/sec
Manufacturer: Chicony Electronics Co., Ltd.
Location ID: 0xfd500000
Current Available (mA): 500
Current Required (mA): 500

Iomega eGo USB/FW400 Portable HDD:

Capacity: 232.89 GB
Removable Media: Yes
Detachable Drive: Yes
BSD Name: disk1
Product ID: 0x0472
Vendor ID: 0x059b (Iomega Corporation)
Version: 0.01
Speed: Up to 480 Mb/sec
Manufacturer: Iomega
Location ID: 0xfd400000
Current Available (mA): 500
Current Required (mA): 0
Mac OS 9 Drivers: No

AirPort Card:

AirPort Card Information:

Wireless Card Type: Broadcom BCM miniPCi 459263-001*

==
*This is a non-standard card. I bought it on eBay for $7 since the Intel card it came with is not supported. If you decide to swap your card for a BCM one, please, ensure the BCM model you buy is supported by your model of HP Pavilion. This is VERY IMPORTANT! HP has white-listed only a small number of wireless cards in their version of BIOS. It won't allow you to use a non-supported version without hacking their BIOS (which is painful and can possibly brick your laptop). Please, google for "104-unsupported wireless device" for more info.

OS

Distro: iDeneb 10.5.7
Kernel: Darwin kernel 9.7.0
Bootloader: Chameleon 1.0.12

Installation selections

Bootloader and DSDT
- Chameleon v1.0.12
- DSTD Patcher
Fix
- Firewire Remove
- idlehaltfix
- Seatbekt fix
- PowerOFF Fix OpenHaltRestart
- VoodoBattery Manager
Kernel
- 9.7.0 Kernel Vanilla
Drivers
- Audio
-- AppleAzaliaAudio
- Chipset
-- ICHx Fixed
- Network
-- Ethernet
--- Intel100ProVE
-- Wireless
--- Broadcom Wifi
-- Video
--- Nvidia
---- Nvidia Enablers
----- NVInject 0.2.1

Post-Installation

1. LAN isn't working. I didn't try to figure out why. Might be a simple problem (but I don't care about it since Wireless is working)
2. Sound works fine but it won't work on headphones. Not a major problem, a relatively minor irritation.
3. If you download DMG files and try to mount them, the whole system bombs. This is a known problem with the Seabelt patch. Here's the suggestion way to fix it. This didn't work for me though. I tried several times but no beans. Finally gave up on it and installed iGetter. As weird as it sounds, when downloading the same dmg files with iGetter, all is well. It also works well if you download a dmg file on another machine and then copy it. No idea why but I'm too old to worry about spending more than 15 mins on this relatively minor issue.

The rest looks good. Enjoy!

This didns't work

How about a guide for DV2000 and Snow Leopard? Any ideas would be really appreciated :0

Hi, i have got the same HP DV2000 i installed 10.6.3 (then u may update to 10.6.6 if u like ) with iatkos DVD. i ordered the wifi card u swapped with. it will come tomorrow. But although i did chose intell v100 pro driver while installing, it did not work. When it sleeps, it doesnt wake up at all... Bluetooth doesnt work. I both have 10,6,6 and win7 64 bit installed with camelon rc5 bootloader. Hope that wifi card works.