yes, i'll make natit for ur videocard, cause curent natit is only from 2600pro
yes u right, also need enw OPenGL.framework
added : antit for ur card (2400) ready, but it uses Hypoprion as it framebuffer drivers, dunno which for 2400, you may need to replace all Hypoprion instances to Iago, in Info.plist for natit.
added2 : made experimental version of autodetection in that natit.
netkas how about me mate?
what can i do?
10 kernels just restarts after initial loadings... what might be the problem?
I can boot fine with 8.8.1 and 8.9.1 but no 8.10.x??? what might be the problem??
once again my system is
Asus P5N32-e SLI mobo (nforce 680i chipset)
Intel Core 2 Quad Q6600 (2.4ghx x 4)
4GB ram (1gb x 4 dual channels))
ATI HD 2900 XT PCI.X 512mb vga (0x94001002)
500gbx3 (~1.36TB) stripe raid on SATA...
300gb on PATA (this is the only way i can boot to osx at the moment)
Nforce Network Controller x 2 (2 x gigabit ethernets) (added dev-id as yukon but no luck it says it doesnt respond maybe hw is off??? guess a nogo at the moment)
usb2.0 x 12port & ieee1394 x 2 port
adi 1988b audio (only azalia works at the moment)
what do u think the problem might be?
I wanna try this new 8.10.x kexts as well... thank you in advance...
@netkas; before I test your new files. There are dependency problems after I update kernel, system.kext, iondrv & co kext.
Only I do not use the dsmos.kext from irc. Will it be the problem?
same here netkas, i did the patch u asked for no hpet, and dependency errors... lots of them... :)
ok netkas, i get pass that dependency errors with a normal system.kext but wen loginwindow loads the gui everything goes black and system gets frozen now...
if i use your system.kext it gives bunch of dependency errors and goes no where after mounting the boot device and shows no report after mounting the boot device...
somewhere in your kext there is dependency check for so many files i have no idea what that is :) but it does checkings i believe, that is causing the error, if old system kext used it loads to black screen but got freeze everything, need to find the good of both :)
in koolkals update package, i see system.kext and systemversion bundle and systemversion.plist files.... are those files might be something to do with this system kext issue? maybe system,kext needs some more files related to it? just and idea?
any more ideas?
(by the way with new system kext from 11 update system loads everything about x2000 drivers i think as i see all the readings from it... just not the gui... for some reason)
BTW Netkas, Maxxuss a while back told that we needed Kernel.Framework to be compatible with the actual kernel version.
So maybe those guys who have some bugs need that Kernel.Framework since it's kernel dependent
System.kext fixed, thx to Diabolik, looks t usual place
hmm, where is this kernel framework? :) usual place?
Will there be further development for 2400HD series? I have updated on Kernal, OpenGL.framework, but Natit fail to load. my device information not found in plist. I have put my EDID data into it but still did not load.
natit had error with detection of hd2400 cards and has support only for 2400pro (94c3), need to know ur devid, and devid of 2400XT