[Leo4all] v2 > isnt working on my gateway

[xypex982]

I have got a spare gateway p4 2.4ghz and wanted to try and install leo4all V2 on it and well so far the disk boots and asks me to press enter to begin booting/installing but it just then goes blank and goes back to the gateway screen. I treid tryping in -v and -v -x, and both dont work. What do I do?

[jashsayani]

I have got a spare gateway p4 2.4ghz and wanted to try and install leo4all V2 on it and well so far the disk boots and asks me to press enter to begin booting/installing but it just then goes blank and goes back to the gateway screen. I treid tryping in -v and -v -x, and both dont work. What do I do?

Pls mention your system config.

And also describe what the screen looks like, any message, etc.

[xypex982]

Its a 2.4 ghz p4 with SSE2, pc 2100 ram 2x 256mb, umm not sure of the mobo because its a prebuilt gatway from 2003, agp geforce 4 ti4600, IDE 40gb HD.

[f41qu3]

Try Leo4All v3 or ToH RC2.

When JaS out 10.5.3 DVD it run on your equipment too.

Stay tunned for news.

Cheerz,

[xypex982]

So I got JAS 10.4.8 installed and it took all day to format the HD and to install it (The install came out to be like 7GB). It goes to the bootup screen with the grey spinning wheel, and after a long while the wheel will stop spinning and eventually reboot. My leo4all disk wont work in any comp now.

Any help guys? What do I do? Also what "distro" or "patched" version is the best for hackintoshing I.E. more support and compatibility

[f41qu3]

Question answered. See this topic: http://www.hackint0sh.org/forum/showthread.php?t=43053

I'm closing this thread now. If have problems to install, open a new thread.