Discuss iPhone 2g, stops working after lock screen. at the Quickpwn - Hackint0sh.org; Hi,
I used quickpawn to jaibreak/unlock my phone and now the phone does not work ...
[Solved] iPhone 2g, stops working after lock screen.
I used quickpawn to jaibreak/unlock my phone and now the phone does not work after going to the slide to unlock screen. Everything but the phone, EDGE, and wifi work. After a little while the signal comes back an everything works again. If i set the phone to "autolock never" and don't accidentally hit the power button (to lock the phone) everything works fine.
Here is what I did:
New refurbished phone from ATT.
Updated to 2.2.1 in iTunes using DFU restore.
Used quickpawn to jaibreak/activate/unlock. (I accicently left the ATT sim in instead of putting in the T-Mobile sim. I don't know if this matters.)
Put in T-mobile sim and everything seemed fine unitl phone autolocked it's self.
I tried redoing restore/quickpawn with 2.2 firmware I had used successfully on another phone but no luck.
I also tried downloading bootneuter from cydia to un-neuter but it hangs like people are talking aobut in this thread.
Anyone have any suggestions?
Last edited by Pod; 02-13-2009 at 05:25 PM.
I swear I searched for hours before I asked the question but I stumbled across Daffy's post in this thread http://www.hackint0sh.org/forum/f127/7699-52.htm and it solved my problem.
By hackint0sh in forum Latest Headlines
Last Post: 05-05-2010, 01:20 AM
By jackrayers in forum General
Last Post: 04-18-2009, 04:12 AM
By GSMsystem in forum iPhone 3G
Last Post: 03-09-2009, 02:30 PM
By vineetmanghani in forum Hardware
Last Post: 07-31-2008, 01:21 PM
By jsteel in forum General
Last Post: 01-09-2008, 11:14 PM