Results 1 to 3 of 3
Discuss Iphone 2.2 quickpwned: No service!!! at the Quickpwn - Hackint0sh.org; hi to all! i've tryed all tricks of this world but nothing had work....iphone 2g ...
  1. #1
    Newbie Array

    Join Date
    Dec 2008
    Posts
    6
    Post Thanks / Like
    Downloads
    0
    Uploads
    0
    Rep Power
    0

    Default Iphone 2.2 quickpwned: No service!!!

    hi to all! i've tryed all tricks of this world but nothing had work....iphone 2g 8gb upgraded to firmware 2.2 with quickpwn: NO SERVICE. please help me to undestrand how to fix it! i've seen different trick like this:

    1a.) uninstall iTunes version higher that 7.5
    b.) delete the "iTunes Library.itl" file located in C:\Documents and Settings\"username"\My Documents\My Music\iTunes
    c.) download and install iTunes 7.5 - if u do not do the sub-step above, iTunes will not start.

    NOTE: i think the step above is what caused my headaches, but since i'm not a programer i'm not sure.

    2a.) using iDemocracy erase baseband and then place into DFU mode(from the things i've read, i do not trust Ziphone)
    b.) restore to 1.0.2
    c.) repeat step 2a - restore to 1.1.1
    d.) repeat step 2a - restore to 1.1.2
    e.) repeat step 2a - restore to 1.1.3
    f.) repeat step 2a - restore to 1.1.4
    ** u do NOT have to jailbreak or activate in between any of these sub-steps above.

    ** NOTE all of those sub-step of 2 might not be necessary but i did it out of paranoia. u might be able to just jump from 1.1.1 to 1.1.4.

    3a.) using pwnage tool to jailbreak your iphone - in your advance tab of the pwnage tool:
    - check "enable baseband update" box
    - check "update bootloader" box
    - check "upgrade to 4.6" box
    - make sure to the "autodelete bootneuter.app" box is NOT checked

    ** finish all the required steps for the pawnage tool

    4.) using the bootneuter app in your iphone, downgrade bootloader to 3.9, neuter and unlock.


    but when i try to restore with the custom firmware itune gave me error 1601

    or this

    I had that same problem....i finally got it....it was easy in the end...>GUESS what i did...

    i'll put it here you should understand my procedure if u've been dealing with iphone for a while...

    i had that No Service problem, no matter what firmware i put the 2g iphone in...was frustrating me...

    finally i uninstalled my 8.XX itunes and installed iTunes 7.5

    Then i downgraded to 1.1.4
    i got error
    1015 or 1013, that is normal
    i used ibrick to boot normal, if screen shows Green just restore again to 1.1.4, try ibrick again and screen will show red and phone boot normal
    Then i used iLiberty and unlock, activate, downgrade to 3.9, youtube activate and installer...
    Then run and iliberty will jailbreak iphone...still it will not work...
    Now: open " _En__ZiPhone_patched_by_kIREmK_04.05.04_G"
    Listen carefully, if you downgrade baseband and did Debug Mode already, all you have to do now is

    JUST CHECK MARK DEBUG MODE & iErase, and press START,

    after that my phone rebooted and it worked well....

    i spend all hours trying all kinds of stuffs and the trick in the end was to do an iErase....

    Cheers, i've tested it and it's 100% bring back my signal...and no more call failed or call back...

    Enjoy!


    but when done, i can'use telephone (STRAGE RED DOT ON TELEPHONE ICON) and wifi!!!

    please help me!!!
    Last edited by phantomEVO; 01-02-2009 at 01:52 PM.


  2. #2
    Newbie Array

    Join Date
    Dec 2008
    Posts
    6
    Post Thanks / Like
    Downloads
    0
    Uploads
    0
    Rep Power
    0

    Default

    i've descovered that when i launch iliberty+ it says "wrong bootloader version 3.9_m3s2"........ i don't know if it is a good or a wrong thing...

  3. #3
    Newbie Array

    Join Date
    Dec 2008
    Posts
    6
    Post Thanks / Like
    Downloads
    0
    Uploads
    0
    Rep Power
    0

    Default

    i've descovered that when i launch iliberty+ it says "wrong bootloader version 3.9_m3s2"........ i don't know if it is a good or a wrong thing...

 

 

Similar Threads

  1. iPhone 3G quickpwned and no service
    By skyline_2k7 in forum Quickpwn 3G
    Replies: 6
    Last Post: 06-14-2009, 11:23 PM
  2. [Quickpwned 2.2.1] WiFi issues.
    By bored in forum Quickpwn
    Replies: 1
    Last Post: 04-12-2009, 01:11 PM
  3. Quickpwned but still no activation!
    By chosendude in forum Quickpwn
    Replies: 16
    Last Post: 01-31-2009, 04:11 AM
  4. Help! Quickpwned 3G won't reboot!
    By badbetty in forum Quickpwn 3G
    Replies: 1
    Last Post: 01-05-2009, 02:17 AM
  5. Bosstools for Quickpwned firmware 2.2?
    By iFiNi in forum Free Toolchain Software
    Replies: 1
    Last Post: 11-24-2008, 06:20 AM

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  
Powered by vBulletin®
Copyright © 2013 vBulletin Solutions, Inc. All rights reserved.
Search Engine Friendly URLs by vBSEO
(c) 2006-2012 Hackint0sh.org
All times are GMT +2. The time now is 10:39 PM.
twitter, follow us!