Discuss [1.1.4] No Signal after using Winpwn at the PwnageTool - Hackint0sh.org; I had my iphone with Bb 4.6, 1.1.4 Baseband 4.02.13_G, I tried to use the ...
[1.1.4] No Signal after using Winpwn
I had my iphone with Bb 4.6, 1.1.4 Baseband 4.02.13_G, I tried to use the Winpwn tool to get the custom logos, so I also used the Bootneuter, after Winpwn was complete, I could'nt get any signal, and if I did it was for just a couple minutes.
Note: If I turn the aeroplane mode on, and turn it off again, I get signal but for a few minutes, then just appears the carrier logo, but no bars, or just says no service. As same if I reset the Network settings.
I tried everything, I restored it to the 1.1.4 , then I used Iliberty, Ziphone still didn't work, I tried with 1.1.3, same didn't work.
Please if someone could help me out!!!
you sir, used an old unlock the first time around.
you have 4.02.13g which is 1.1.2's baseband or geohots first unlock script. basically whatever you used downgraded your baseband when it unlocked instead of ur bootloader hence ur unlock isn't working. bootneuter was not designed for 4.02.13g
you need to fresh restore to 1.1.4 again thru itunes, then re-pwn, then restore to custom 1.1.4 unless u only want the boot logos lol
dang, whata mess u made for some boot screens
originally OTB 1.1.2 iPhone 4.6BL
now blackra1n'd 3.1.2
By iFon in forum PwnageTool
Last Post: 12-01-2008, 08:58 PM
By abgordon in forum Winpwn
Last Post: 09-21-2008, 02:13 AM
By jdetmold in forum Old *pwn Solutions
Last Post: 09-17-2008, 10:24 AM
Last Post: 08-12-2008, 09:36 PM
By big_coop69 in forum PwnageTool
Last Post: 04-21-2008, 09:16 AM