Discuss Linksys Wmp54gs v1.1 Not Working at the Kernel / Kext (Driver) Support - Hackint0sh.org; so here's the scoop.
i installed iatkos s3 v2 snow leopard 10.6.3 distro (with the ...
Linksys Wmp54gs v1.1 Not Working
so here's the scoop.
i installed iatkos s3 v2 snow leopard 10.6.3 distro (with the broadcom wireless drivers checked under installation customisation), and everything works perfectly except for my linksys wmp54gs v1.1 wireless pci card.
the pci card has a Broadcom 4318 chipset and from what i've been reading, this is supposed to work 100% out of the box. but no matter what i do, Airport does not detect it.
i've already tried the method posted [here] with the shell command, and no luck :/
as shown in the screenshot below, system profiler shows the wireless pci-card as pci14e4,4318 which is the device id. the type of pci card is shown as "other network controller" and the drivers are apparently not installed.
iAtkos S3 v2 Snow Leopard 10.6.3
Core 2 Quad Q6600
Intel Bad Axe 2 d975xbx2 Motherboard
4GB DDR2 OCZ Platinum RAM 800mhz
320 Seagate S-ATA HDD
nVidia 8800 GTX
Dont Check The Broadcom Driver,u shouldnt have to check any drivers for the card
By Count de Monet in forum Hardware
Last Post: 06-22-2012, 06:19 AM
By Iman07 in forum Kernel / Kext (Driver) Support
Last Post: 09-12-2009, 06:09 PM
By Count de Monet in forum Archiv (Leopard)
Last Post: 11-20-2008, 07:19 PM
Last Post: 11-19-2008, 12:13 AM
By Ryck in forum Hardware
Last Post: 10-07-2008, 09:51 PM