Discuss Screen garbled after install on GMA950 / Inspiron 6400/E1505 at the Kernel / Kext (Driver) Support - Hackint0sh.org; Hi Guys,
I've tried an install of 10.5.5 using both iDeneb and iAtkos on my ...
Screen garbled after install on GMA950 / Inspiron 6400/E1505
I've tried an install of 10.5.5 using both iDeneb and iAtkos on my 6400,
I've got multicore disabled in the bios (also disabled sound, card reader), and i've always just left the standard kernel.
Each time, no matter what drivers i choose (normally i pick the GMA950 if available), after the Apple screen dissapears, i get
1. 2 seconds of blue screen
2. screen goes black
3. I connect an external monitor
4. Press Fn + F8
5. Screen shows garble/corruption
Sometimes in the corner i can see the rainbow cursor spinning above all of the corrupt junk... but i can't move it.
The harddrive is spinning and churning away like its loading something.
I have tried
2. various combinations of "GraphicsMode"= (in 8,16 and 32)
Been at it for 3 days now, can anyone help?
Screenie below of the garble...
Temporarily Fixed.... not hardware accelerated, but working ok, allows me to get in and mess around. Details below.
rm -rf AppleIntelGMA950.kext
rm -rf AppleIntelGMA950GA.plugin
rm -rf AppleIntelGMA950GLDriver.bundle
rm -rf AppleIntelGMA950VADriver.bundle
rm -rf AppleIntelIntegratedFramebuffer.kext
rm -rf AppleIntelGMAX3100.kext
rm -rf AppleIntelGMAX3100FB.kext
rm -rf AppleIntelGMAX3100GA.plugin
rm -rf AppleIntelGMAX3100GLDriver.bundle
rm -rf AppleIntelGMAX3100VADriver.bundle
Achieved Full 1280*1024 Resolution, buy installing the Recommended Driver for my graphics chipset using osx86Tools. Once i rebooted i had full res.
Animations are a little slow, but looks much better.
By pecos5 in forum Kernel / Kext (Driver) Support
Last Post: 05-20-2011, 04:23 PM
By centosltib in forum Installation
Last Post: 04-28-2011, 03:25 AM
By midnight1xcoffee in forum Kernel / Kext (Driver) Support
Last Post: 02-23-2011, 07:15 PM
By umeshg in forum Installation
Last Post: 07-02-2009, 09:08 PM
By blip911 in forum Installation
Last Post: 02-21-2009, 02:27 PM