FX5200 and 1920x1200
CPU: AMD64 3000+
MOBO: Nforce3 ultra (Gigabyte)
Ram: 1GB kingston DDR400
HDD: 40GB WD
LCD: Dell 2405 FWP
I installed Leo4All v3 final, installed NVinject 0.2.1.
the card is recognised, and can run at all resolutions under 1280 x 1024, but I want to run it at 1920 x 1200, which I have been doing under winxp.
so what do I have to do?
am really confused now...
during installation, I had the option of choose NVidia KEXT 10.5.2 (~50mb) as well as NVinject 0.2.1 (~40kb), i tried and after the install system would not boot, something to do with NVDA, i guess it is a problem with the nvidia kext.
As per instruction of leo4all, installing video driver during system install is not recommended. so i subsquently left out the Nvidia kext and only selected nvinject 0.2.1.
Result is that system install was successful and in system overview it says i am using nvinject as graphics's rom. but CI is software and QE is not enabled, as well as incorrectly reporting 1024mb of VRAM, i should only have 128mb. (and the problem of not able to use more resolution than 1280 x 1024)
then I read instruction from the installation instruction thread in nvinject forum, apparently i need some kext for this to work, and I dont have them!
and of the required files i have got:
(I have installed AGPGart 2.7.1, and now it does recognise the card as on AGP bus, I also edited IOPCImatch string to 0x032210de&0x0000ffff, i am not sure if i should have done this... )
1, do I need to install the nvidia 10.5.2 kext?
2 and since i didnt install that 50mb of 10.5.2 nvidia kext during system installation, where do I find them now?
really appreciate it if someone can point me to the right direction.