Hello all,

Yesterday i flashed the 3.0 beta 2 firmware to my iphone following the steps described in the following topic : http://www.hackint0sh.org/forum/f201/69432-9.htm

This all went fine. I called with it for a day. Then suddenly the phone wouldnt disconnect so i waited till it disconected. Then i tried to call myself again but the phone does not ring. I powered off the iphone and powered it on again. Now the iphone is only showing the apple logo and wont go any further.

Is there any way i can restore a previous image to the iphone or reset it in any way ?

best thing to do i think is to restore the 3.0 beta 2 firmware back on again and see if this helps. sometimes when you just get the apple logo and nothing else it can be a sign of a faulty comms or logic board. I experienced this in my 2G iphone and had to have them replaced. restoring back to 2.2.1 is not an easy process for people not experienced in the processes.

So i can just reflash the 3.0 b2 to the iphone even if only the apple logo is showing ? I'm gonna try that. Thx for the reply

Oke i restored the 3.0 beta 2 firmware again and its working for now thanks for the help.

I hope that you realize that 3.0b2 is on the verge of expiring and self destructing...

You may want to try for 3.0b3 if that whole "phone ringing" thing really matters that much for you.

~Adrian

Originally Posted by Adrian Fogge

I hope that you realize that 3.0b2 is on the verge of expiring and self destructing...

You may want to try for 3.0b3 if that whole "phone ringing" thing really matters that much for you.

~Adrian

I know that. I'm just experimenting. I have back-up phones laying around. Thank you for the advise.