Code:
- IOSDIOController::performAsyncBlockTransfer(): SDIO Command failed, SDIO Cmd Timeout
- IOSDIOIoCardDevice::cmd53Write(): To Fn1:0x10000 from md {0x81c3c040, 1024}[0:512] in [32] with 0x0 failed, SDIO Cmd Timeout
- AppleMRVL868x::loadMainProgram(): Device write failure: SDIO Cmd Timeout
- AppleMRVL868x: ERROR - Unable to load main program image.
Code:
- Sending EBL Loader...
- Sending EBL Loader Length...OK
- Sending EBL Loader Data...AppleS5L8900XSDIO::sendCommand(): CMD52 Failure - SDIO Cmd Timeout: arg(0x00000a00), error count(1), dsta register(0x0000c004)
- OK
- Sending EBL Loader Checksum...OK
- Timed out
- Giving up
- !!! Exception at :0:
- - BBUReturnTimedOut(10)/2: Receiving EBL Loader checksum response failed
These both indicate a level of hardware failure with your baseband. Did the phone get dropped or wet? That is usually the cause of this type of hardware failure, though it is possible that it just 'went bad'. Is the device under warranty? Your best bet is likely to bring it to Apple to get it replaced.
Bookmarks