Just went through the activate/jailbreak/unlock process with independence 1.2.3 and anysim 1.1 successfully.

I then installed minicom as I am curious to see the output of the command AT+XIMSTATE=1

Surprisingly, I got the following result:

+XSIM: 1

+XLOCK:

Never seen that before. Anyone know that means?

Originally Posted by sylvester

Just went through the activate/jailbreak/unlock process with independence 1.2.3 and anysim 1.1 successfully.

I then installed minicom as I am curious to see the output of the command AT+XIMSTATE=1

Surprisingly, I got the following result:

+XSIM: 1

+XLOCK:

Never seen that before. Anyone know that means?

Is that all you got? the results should be a longer line e.g.

+XSIM: 2

+XLOCK: "PN",1,0,"PU",5,0,"PP",5,0,"PC",5,0,"PS",5,0


I have no idea what +XSIM: 1 means....

refer to below:

+XSIM: SS

+XLOCK: "PN",X1,X2,"PU",X1,X2,"PP",X1,X2,"PC",X1,X2,"P S",X 1,X2(the only lock present is the PN lock)

SS:

0=No SIM Inserted

2=SIM Ready

6=SIM Busy

X1:

0=Unlockable(i assume without attempt counter)

1=Unlockable

2=Unknown(i have never seen this)

3=Attempt Limit Reached

4=Unlocked and Lockable

5=Unlocked

X2:

0=SIM Valid

1=Unknown(this gets set for PN when unlock is attempted)

4=SIM Not Valid

These values weren't found in any manual, and were all determined either empirically or by reversing the firmware.

What I posted was exactly what I saw in the screen, ie "+XSIM: 1" and nothing after "+XLOCK:". That's why I called it "strange"! I was expecting the output like what you listed.

I even tried pull the SIM card out and put it back in while minicom is still running. It poppeds the message "+SIM: 0" when I popped the SIM card out and "+XSIM: 1" when I pushed the SIM card back in.

Originally Posted by sylvester

What I posted was exactly what I saw in the screen, ie "+XSIM: 1" and nothing after "+XLOCK:". That's why I called it "strange"! I was expecting the output like what you listed.

I even tried pull the SIM card out and put it back in while minicom is still running. It poppeds the message "+SIM: 0" when I popped the SIM card out and "+XSIM: 1" when I pushed the SIM card back in.

Is your unlocked 1.0.2 working fine?

Originally Posted by ugene

Is your unlocked 1.0.2 working fine?

I followed independence's instruction to upgrade it to 1.1.1 then do the activation/jailbreak before running anysim 1.1. So it is unlocked and running 1.1.1. I can make/receive calls and send/receive sms.

Ok, got it: It is the SIM PIN causing this state. Deactivate the PIN and read the XSIMSTATE again. The output will be fine.