I'm just totally confused but all the guides are for 1.1.1. Most say for 1.0.2 is activate using Independence.

1. Opened up INdepedence1.3Beta.--> Activate/SIM tab -> Activate Phone
2. It asks for firmware which I used 1.0.2 1c28_restore
3. Error message " Failure, Error entering Recovery mode"

But If i get the iphone in Recovery mode, I can't do the above in Independence.

I know I must be doing something wrong but can't figure it out .

Thanks

Originally Posted by [Q]

I'm just totally confused but all the guides are for 1.1.1. Most say for 1.0.2 is activate using Independence.

1. Opened up INdepedence1.3Beta.--> Activate/SIM tab -> Activate Phone
2. It asks for firmware which I used 1.0.2 1c28_restore
3. Error message " Failure, Error entering Recovery mode"

But If i get the iphone in Recovery mode, I can't do the above in Independence.

I know I must be doing something wrong but can't figure it out .

Thanks

In my opinion Carlos Valdosta did the best and easiest to follow guide here:

http://www.hackint0sh.org/forum/showthread.php?t=6637

I'm an idiot and I managed to get my 1.0.2 to run on Claro, Peru with this guide!

Grid

I agree. Carlos did an excellent job with his guide for virgin 1.0.2 -
All the steps are still good EXCEPT for the unlock part. Do not use anything but anySIM 1.1 now (use anySIM-1.1.pxl now)

At the time he did his write up, anySIM 1.1 was not available. I have not looked at his guide in a while. May be he did update it to use anySIM 1.1 exclusively.