[1.1.4 (1.1.2 OTB)][ziphone] Restore always results in recovery mode
1.1.2 OTB -> ziphone 2.5 -> 1.1.4
iPhone was running fine for weeks.
A couple of days ago after a phone call, I had a 20% battery warning, pressed dismiss. A few moments later I set a new alarm, and... all of a sudden iPhone was displaying the "Connect to iTunes" screen.
So I am trying to restore 1.1.4 with iTunes (latest 7.6), restore ends as expected - without any errors, but iPhone restarts in recovery mode again, showing the "Connect to iTunes" logo.
What I tried so far is:
- Recovery mode 1.1.4, 1.1.2
- DFU mode 1.1.4, 1.1.2
Did it again and again in combinations... same result always.
Also tried ziphone's normal mode after that, ibrickr...
I have installed iBooter.
Here is the output:
[NAND] BANKS_TOTAL 4
[NAND] BLOCKS_PER_BANK 8192
[NAND] SUBLKS_TOTAL 8192
[NAND] USER_SUBLKS_TOTAL 7744
[NAND] PAGES_PER_SUBLK 512
[NAND] PAGES_PER_BANK 1048576
[NAND] SECTORS_PER_PAGE 4
[NAND] BYTES_PER_SPARE 64
[FTL:MSG] FIL_Init [OK]
[FTL:MSG] BUF_Init [OK]
[FTL:MSG] VFL_Init [OK]
[FTL:MSG] FTL_Init [OK]
[FTL:MSG] VFL_Open [OK]
[FTL:MSG] FTL_Open [OK]
Boot Failure Count: 0 Panic Fail Count: 1
Delaying boot for 0 seconds. Hit enter to break into the command prompt...
Endpoint direction info:
Entering recovery mode, starting command prompt
Not sure what that "Panic Fail Count" means, is it a hardware problem?
Any specific environment variables that I should try to set with iBooter?