[1.1.3] official dev JB = recovery mode at every reboot ?
hi all, i have seen some mention of this issue here in the fora but it hasn't gotten all that much attention from what i can see, so i am wondering whether this is really an issue that affects all installations or only some? i updated my 1.1.2 iphone to 1.1.3 using the dev release via terminal and sftp, and it seemed to install and run fine at first, aside from a few snafus, some of which have been addressed w/ patches and hacks. but today i started experiencing what i cannot think of as other than a show-stopping bug.
i was installing some apps via the installer and one required a reboot, the app in question is listed as 1.1.3 compatible so i figured there could be no harm... but instead of rebooting back to my springboard, i found myself in recovery mode. inDependence was easily able to kick it out of recovery but that really isn't the point... i found myself w/out a phone for a good part of the day since I DON'T CARRY A LAPTOP AROUND JUST TO KICK MY PHONE OUT OF RECOVERY MODE! i mean, that is a pretty serious bug if it is widespread, i did a clean reinstall this evening and did a regular hard reset just to see what would happen upon reboot... sure enough, back into recovery mode.
this seems really bad if you want to rely on your phone when out and about, and don't want to be saddled w/ 5+ lbs of hardware just to reboot a phone... is this not really a widespread issue, are all iphones updated via the official dev JB exhibiting this behavior or only some? i am sitting at yet another clean 1.1.2 install right now and wondering whether i should try the earlier 'Nate' JB instead this time, any input as to which direction to go here friends..?