Discuss Guide for PSS sim on OOB 1.1.2 iphone at the iPhone "2G" (Rev. 1) - Hackint0sh.org; Dear all this a brief guide for the PSS sim application on the OTB 1.1.2 ...
Tutorials for PSS sim unlock on OTB 1.1.2 iphone
Dear all this a brief guide for the PSS sim application on the OTB 1.1.2 iphones or wth new bootloader version iphones, this means this also applicable to the iphones sold in Europe.
This guide should applied to Turbo sims...
The key point here in this guide is to jailbreak "ONLY" no need to "UNLOCK" the iphone.
So even apple release a new firmware somewhen later, this PSS sim "PROBABLY" will be the fastest way to "UNLOCK" your iphone. Because it only required the "JAILBREAK" and need not to "UNLCOK"... This PSS sim also applied for any version of firmware form 1.0.2 , 1.1.1 and 1.1.2 and also works with "BOTH BOOTLOADER" versions like I said before.
And this PSS sim also comes with a feature of holding two sim cards together at once, meaning that you can have 2 phone lines for the iphone, with only one line stanby at a time, you can switch the lines between sim application in the phone setting, no need to turn off your phone and pull out the sim to replace it, this is very useful for those traveling a lot or want to keep the office line separate from his/her private line sepacially after office hour.
Here is how it works.
1.First restore your OTB 1.1.2 iphone to 1.1.1 by placing the iphone to recovery mode. Put it out if the recovery mode when it is done.
2.Then activate iphone by using the the method form www.jailbreakme.com you can find the guide from www.modmyifone.com a guide called "Jailbreak the iPhone 1.1.1 out of the box".
3.Install the "OktoPre" from the tweaks 1.1.1 in the installer.
4.Then open itunes and "UPDATE" your iphone to 1.1.2.
5.Download "Jailbreak 1.2" and unzip it then run "Jailbreak.rar" in OSX or "Windows.bat" in XP, remember to select install SSH and then hit Jailbreak, remember to place your sim with PSS sim together and insert it into iphone before you hit the Jailbreak.
6.After few reboots then you will see signal bar coming up on the upper left corner, finally make sure you install "iWorld" from Tweaks1.1.2 folder in installer and rub it before you can start using the phone functions.
If you guys have any enquiries regarding the PSS sim, please feel free to contact me through my pm.
Last edited by parkertseng; 12-01-2007 at 02:53 PM.
By djpav in forum Free Toolchain Software
Last Post: 04-22-2012, 07:31 PM
By PingunZ in forum Archiv (Leopard)
Last Post: 10-05-2008, 05:43 AM
By darkprince in forum iPhone "2G" (Rev. 1)
Last Post: 01-26-2008, 03:31 PM
By tupperware in forum General
Last Post: 01-06-2008, 04:37 AM
By tetsu in forum iPhone "2G" (Rev. 1)
Last Post: 10-24-2007, 04:57 PM