I just used ibrikr 0.9 to jail break a 1.02 firmware phone. Since it took longer than normal I unplugged the phone as the screen instructed and proceeded to power cycle the phone.
Now this is the symptoms I'm seeing.
The phone will start with a Apple screen.

Then boot with a yellow triangle.
Flashing the blue colored background with the yellow triangle.
Then a command line screen flashes a shit load of command. Kinda like booting in DOS days.

And it just keep re string these txt over and over.
"BSD root: md0, major 2, minor 0"

The power button will not respond by itself.
The phone will reboot only when the power and home key is held for 10 seconds.

HELP! What the hell is going on?
I've unlocked over 45 phones using Ibrickr 0.8 without any problems.
iBrickr 0.9 horror story number 1!

What shall I do now?

I will record a video and post it up soon.

try running apptap on it it might fix the problem

will try that right now.

that didn't work. The phone didn't respond too well, it's doing the same thing.

keep trying to restore, if you get the yellow triangle at all it should work eventualy

when off hold home and plug into PC keep holding till restore msg comes up then hold shift and click restore and choose the 1.0.2 image

Good Luck

I've tried that over and over.
This is the video of it

http://youtube.com/watch?v=UYVlmsrPBGk

i had that problem today unlocking my bro new iphone. press the red button.

what red button? on what program?

see the problem is without a cable plugged in it stays on yellow triangle.
As soon as I plug in a cable it will go in to the command line crap automatically and when it's done it just repeat this string over and over
BSD root: md0, major 2, minor 0

I know the quality of the video is crap but my phone is all I got to record videos with right now.

Ok figured it out.