Discuss BBupdater in endless loop, can't run minicom help? at the iPhone "2G" (Rev. 1) - Hackint0sh.org; Hi,
after several successful downgrades, I am lost on an upgrade actually.
I restored a ...
-
BBupdater in endless loop, can't run minicom help?
Hi,
after several successful downgrades, I am lost on an upgrade actually.
I restored a phone that was 1.0 to 1.02 everything seemed fine.
ran anysim 1.1.1, it completed succesfully, then it said no wifi.
after a restore again, ..still no wifi
several upgrades/downgrades later, itunes wont complete a restore without error.
I use apptapp to boot to the activate screen, jailbreak, activate, install BSD, terminal.
attempt to use ieraser, it works, bbupdater -v says no response, I try to put on the version 3.14 baseband, and bbupdater just keeps going and going..
it goes thru to 100 on 2 separate counts (like it should) then comes with an error something about the fls or the checksum then just restarts the whole process.
i try to run minicom -s /dev/tty.baseband and it says no cursor motion capability.
i am LOST.
p.s. i have to use terminal svn113 because any other version exits after only 3 characters, why is that?
-
-
Try running the bbupdate to 3.14, then right after it fails out, run ieraser.
-
-

Originally Posted by
norenore
Try running the bbupdate to 3.14, then right after it fails out, run ieraser.
Thanks,
tried that after it ran about 20 times in a row then kicked out.
No luck.
ieraser finishes, then the baseband is non responsive, flashing just runs 20 times (about 30 minutes or so)
and kicks out :
Error : failed to dowload FLS: Expected checksum 6904 god 380B
Done
tried with both 3.12 and 3.14 firmware, ieraser with all secpacks too.
anyone have the 4.01 bb firmware?
Similar Threads
-
By annoyingdrew in forum Installation
Replies: 11
Last Post: 04-19-2010, 09:42 PM
-
By macuser in forum Tiger
Replies: 11
Last Post: 02-14-2009, 04:25 PM
-
By komes in forum PwnageTool
Replies: 4
Last Post: 07-21-2008, 06:56 AM
-
By saif_so in forum iPhone "2G" (Rev. 1)
Replies: 10
Last Post: 12-28-2007, 02:18 AM
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules
Bookmarks