HEY GUYS

my iphone is brand new with firmware 1.0.2
i connected it to my mac and used independence to jailbreak it
then i connected it to my windows pc and used PACAY to activate youtube and activate the phone
i connected back to the mac
and installed ssh using independence
i installed apptapp on my phone using my mac
i downloaded bsd subysytem and open ssh on my iphone

i tried opening up the iphone on my mac using fugu
but it said "permission denied"
i tried transfering the anysim 1.0.2 file via independence but its tellin me
"please ensure it is connected to a network or ssh is installed properly"

i finally used ifuntastic3.5.5 and copied anysim file into application
the app shows up on the spring board after a reboot and when i click on it..
it freezes...the slider doesnt move forward..
after a minute it goes back to the spring board..

please help!!
wat m i doing wrong
(i did the same things on my previous iphone and it worked,except that my iphone did open up on fugu and independence and i copied iUnlock onto my phone and ran it successfully)

please help1!!
thanksalot

Oh boy, how do you spell the word COMPLICATED?

Short "how-to-do-it" with a MAC:
1. do a full 1.0.2 recovery (caution: DO NOT update to 1.1.1!)
2. use INdependence (latest version) to activate
3. use AppTapp installer to install installer.app
4. restart iPhone
5. start installer.app and install Community Sources, BSD Subsystem and OpenSSH
6. restart iPhone
7. use INdependence to jailbreak iPhone (if not already jailbreaked)
8. add the AnySIM repo to installer.app by using the AnySIM link on the iPhone Dev Team Wiki Status Page
9. start installer.app and install AnySIM
10. start AnySIM and make sure that the SIM card you want to use is inside the iPhone

Some of the above steps may not be absolutely necessary and it may work with leaving them out but do it step by step and you save yourself a lot of trouble.
This method includes activation, YouTube issue and unlocking.

Good luck.