Discuss [Advice] Status of IPSF Geohot after 3.9FBL at the iPhone "2G" (Rev. 1) - Hackint0sh.org; Yesterday I made a Testpoint to my 1.1.2 OTB phone (previously unlocked via HW unlock ...
[Advice] Status of IPSF Geohot after 3.9FBL
Yesterday I made a Testpoint to my 1.1.2 OTB phone (previously unlocked via HW unlock in order to downgrade to 3.9) in order to install 3.9FBL bootloader.
Previous to the install of the new bootloader i was unlocked via IPSF like method, after I testpointed, loaded the 3.9FBL bootloader and restored to 1.1.4 via itunes and jailbreak/activate via ziphone (no unlock) I installed signal.app but the phone didn't seem to respond so I had to install unlock 1.1.4 from the iclarified source on the installer.
I would like to know what is the exact status of my IPSF unlock, what should I do in order to make it work again as I dont like the anysim method.
Should I install the IPSF again?, or do I have to make a restore of the seczone and then install the IPSF again?.
Also, in case that 4.6_Geomod or pwned arrives and I update the bootloader, the IPSF unlock would be useless again?
por ahora IPSF no funciona nativamente, pero con la ayuda de Signal.app si lo hace.
en todo caso es posible liberar ziphone, pues conviven bien IPSF con anySIM en el firmware 1.1.4, puedes restaurar a la 1.0.2 y veras que aún esta liberado.. si lo verificas corriendo IPSF veras que todo esta ok
nada más que la gente de IPSF team parece que nos dejo botados.
contretasg I already ran Signal.app (as stated above) and the unlock seems not responding.
By Blurtigo in forum PwnageTool
Last Post: 07-28-2008, 02:53 PM
By darveesh in forum iPhone "2G" (Rev. 1)
Last Post: 07-12-2008, 11:57 PM
By vomer in forum iPhone "2G" (Rev. 1)
Last Post: 03-03-2008, 06:50 AM
By akiacat in forum iPhone "2G" (Rev. 1)
Last Post: 02-19-2008, 12:43 AM