Discuss [Advice] bad bootloader at the iPhone "2G" (Rev. 1) - Hackint0sh.org; Hi, i have an Iphone 1.1.3 Otb that a friend gave me, it was jailbrake, ...
[Advice] bad bootloader
Hi, i have an Iphone 1.1.3 Otb that a friend gave me, it was jailbrake, activated and unlocked, but it had no service,
So I restored and updated the firmaware to 1.1.4
jailbraked, activited and unlocked again with iliberty (3.9 FB)
Now I dont have EMEI, CCID, WIFI, BT OR MODEM FIRMWARE,
I have tried, many restores, Iliberty (stays on fixing bootloader), pwnage tool (it does everything it boots but when it gets to bootneuter it gets stuck un determining configuration
Is there a way to Flash the bootloader that I Think is the one causing the crash??
İf you are lucky and if it is 3.9 really fakeblanked before thats good..Try restoring stock 1.0.2 or 1.1.1 .This flashes a fresh stock 3.8 bootloader to iphone..Then you can use bootneuter to flash 3.9 or 4.6.
This is why I am still using iPlus for unlocking.
Doctor of the all iPhone'S
I got emei, ccid, wifi, and everything but service "no service"
I tried downgrading to 3.8 but still no service.
so I am suspecting there is a hardware problem with the iphone.
By mallekha in forum Hardware
Last Post: 06-28-2008, 07:45 PM
By pogramci in forum iPhone 3G
Last Post: 06-04-2008, 10:55 PM
By happysmp in forum iPhone "2G" (Rev. 1)
Last Post: 05-22-2008, 04:04 PM
By amonramses in forum iPhone "2G" (Rev. 1)
Last Post: 05-07-2008, 11:59 AM
By Baxt3r in forum General
Last Post: 01-14-2008, 12:19 AM