i was at the part that running iunew command while connecting test point. after couple tries. the phone is out of battery and i did not realized before it turns off. now the phone is unintentionally restarted....

connecting the usb cable and start the phone again... now wifi is lost and no sound. it also overheats (maybe).... I can still get into terminal window.
What should i do now?

Can anyone tell me what is the procedure to reverse what i did before since ienew command before gets my phone a 1.1.3 baseband (is that right?) i was at 1.1.1 doing all these. i want it back to my 1.1.2 OTB baseband.

also, if i want to continue to hw unlock, what should i do now after the phone is restarted? i can't continue, can I?

Common sense. Turn it on, continue trying the iunew command. everything will be fine.

Hi, are you suring i can continue my hw unlock?
but i remembered tutorial says that it is very important that i do not restart the phone after ienew.

so now do i have to run ienew again?

thank you.

if ienew ran properly u dont need to run it again.

just testpoint and run iunew.

whats that about 1.1.3? did u restore to 1.1.3? if u did ur fkd. dont restore to anything till ur done testpoint iunew, and if u ever have to restore dont go 1.1.3

i remember the warning that never try to restore the phone after ienew. (there is also a warning that do not restart the phone after ienew. that is why i am worried because i unintentionally did).

i did not do any restore. am i still safe?

i am now at the part that the phone has restarted after running ienew and iunew (test point not yet successful)

so i can just continue to do iunew? thx

yes of course. just continue with testpoint stop stressing ur fine

Originally Posted by madB

yes of course. just continue with testpoint stop stressing ur fine

thx a lot!

bin, did you manage to do it?
I have a similar problem, I'm getting the "Spamming AT, waiting for a response" message after I run iunew, and that's it
if baseband is unresponsive to pinging, it means that it was erased, so ienew worked, right?

i didnt managed to do it. got problem... i think probably because of the restart...

now when i run ienew, it says
"waiting for data" and then "can't write"

when running iunew, it says
"zsh: bus error iunew"

Could anyone help??