Discuss [1.1.1 OTB 1.0.2] Problem: 1.1.3 didn't work, went back to 1.1.1 but can't unlock at the iPhone "2G" (Rev. 1) - Hackint0sh.org; Hey Guys
I had previously upgraded to 1.1.2, early on when it was considered risky. ...
-
[1.1.1 OTB 1.0.2] Problem: 1.1.3 didn't work, went back to 1.1.1 but can't unlock
Hey Guys
I had previously upgraded to 1.1.2, early on when it was considered risky. Recently I tried to install 1.1.3 but some problem occurred after installing preventing me from using it . So I went back down to 1.02, 1.1.1. I tried unlocking with ANySim1.1 but it didn't work, it said it unlocked but nothing worked - selecting carrier brought up an error ("error") and threw me back to the main menu.
So I figured i'd try 1.1.2 and AnySIM 1.2.1u. No good, I couldn't get it to unlock (again, it says unlock, but doesn't).
Finally I went back to 1.0.2, 1.1.1. I have the modem firmware 04.02.13_G. Installed AnySIM 1.2.1u again, same problem.
Anyone know what I should do? I looked around a bit but can't find much. Preferably I want to be on an unlocked 1.1.3, but ATM I can't even unlock 1.1.1...
-
-
Senior Professional
Array
run the virginizer, reinstall 1.1.1 then run anysim from i.unlock.no
-
Similar Threads
-
By xellos2099 in forum Ultrasn0w (3G(S)/iPhone 4 unlock)
Replies: 3
Last Post: 09-04-2009, 10:16 PM
-
By das in forum PwnageTool
Replies: 3
Last Post: 07-26-2008, 10:01 PM
-
By wlp5 in forum Free Toolchain Software
Replies: 4
Last Post: 03-04-2008, 11:22 AM
-
By smallpotato in forum iPhone "2G" (Rev. 1)
Replies: 4
Last Post: 11-28-2007, 09:27 AM
-
By reader in forum iPhone "2G" (Rev. 1)
Replies: 0
Last Post: 09-27-2007, 05:43 PM
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules
Bookmarks