Discuss [1.1.1 (1.1.2 OTB)] HW unlock step 3 error: Can't write data at the iPhone "2G" (Rev. 1) - Hackint0sh.org; Hi there.
I have some experience in hardware hacks, so I gave the guide a ...
[1.1.1 (1.1.2 OTB)] HW unlock step 3 error: Can't write data
I have some experience in hardware hacks, so I gave the guide a shot, but at step three where i'm suposed to enter
into the console, i get the following message:
# Resetting the baseband...Done
# Opened: /dev/tty.baseband
# ieraser for 112OTB: tool by geohot
# Waiting for data...
# Can't write
I downgraded to 1.1.1, jailbroke, installed BSD subsystem, term vt 100 and Bootloader downgrade. opened the phone, entered flight mode and here we are...
I'm not suposed to connect the testpoints untill step 4 right...
Can you run bbupdater -v and post results?
first: sry for my bad english
Error: Failed to initialize comm layer:
Have you unload these plist? After i do this, it goes.
Step 3: Erase baseband
Go to Settings on your phone and turn on Airplane Mode (if you use SSH, enter this command instead: launchctl unload /System/Library/LaunchDaemons/com.apple.CommCenter.plist) . Then launch the terminal by tapping the Term-vt100 icon on your springboard.
Type these command:
the iphone ask me "did you erased your flash first?"
What i am making wrong?
Last edited by kIREmK; 01-21-2008 at 06:18 AM.
dude i had the exact same problems. including did u erase your flash first
i restored to 1.1.1 and now back to 1.0.2 and gonna try all over again
PLS let me know how u solve it
If youve updated to 113 it should write that error
By volkspost in forum iPhone "2G" (Rev. 1)
Last Post: 11-02-2011, 04:30 AM
By MCHuertas in forum iPhone "2G" (Rev. 1)
Last Post: 02-09-2008, 01:30 PM
By xasan in forum iPhone "2G" (Rev. 1)
Last Post: 11-02-2007, 03:12 AM
By nehvada in forum iPhone "2G" (Rev. 1)
Last Post: 10-10-2007, 05:30 AM