Hello everyone!
Well let me cut to the chase! My system specs are as follows:
-AMD Phenom II X4 840
-NVIDIA GeForce 6150SE nForce 430 Chipset
-ATI Radeon HD 5570
-4GB DDR3 RAM
-625GB SATA WD HDD
(DVD DRIVE: UNSURE but works perfectly fine!)

Well I have attempted to install iDeneb v1.3 but once my install is finished i get to the keyboard setup, as expected but once I get to the page where it asks me if i want to transfer files from another Mac it gets stuck when i press continue and it re-boots .

Second problem is that when I attempt to boot iPC 10.5.6 from the disk my system restarts and never enters setup. I attempted to use this distro on another VERY old laptop and it booted just fine.

Third and finally comes Hazard Snow Leopard 10.6.2. I have successfully installed this distro a few months back but had always had some bugs/glitches with it and i could never utilize my monitors full resolution (this was before my GFX card was installed). Now when I attempt to boot a copy of that distro it does the same as the iPC distro.

This is obviously very frustrating for me so at this point any help would be very much appreciated! Thank you so much