so i got snow leopard installed... and im running chameleon 2.

when i start to snow leopard i dont get any kernel panics.. but im just stuck on a spinning gear...

anyone got any ideas?

the gear spins it doesnt freeze at all

when i boot in Verbose mode: ACPI_SMC PlatformPlugin::pushCPU_CSTData - _CST evaluation failed
Apple USBEthernet: Ethernet address 00:1f:5b:fe:d4:c7

then it just stops there..

when i plug the ethernet i then get
ACPI_SMC_PlatformPlugin::push_CPU_CSData - _CST evaluation failed

so with chameleon 2rc1

i'll boot using ignore caches.
i got in. i was able to register then started to use and got a kernel panic

restarted
got into the account now. set up itunes then got a kernel panic...
any ideas???


will only boot up when i ignore caches.
and it'll run for about 5 minutes before i get a kernel panic

Same problem. Stuck on spinning gear at start up. Since this question is a year old and no one has responded, is it safe to say no one is going to? I hope not...

It would be better if you post your system specs, steps you've done, OSX version/release/method, how it happens.
People sometimes don't reply to a post with no info beside installation doesn't work.

Boot with -v for possible error message as well.