Hello !
i'm trying to install Snow Leopard Universal 3.6 (10.6.2) on my computer with P5W DH Deluxe.But after the setup begin , i see Starting Darwin and the computer restart.
What can i do ?
Thank you in advance !
Printable View
Hello !
i'm trying to install Snow Leopard Universal 3.6 (10.6.2) on my computer with P5W DH Deluxe.But after the setup begin , i see Starting Darwin and the computer restart.
What can i do ?
Thank you in advance !
check the install guide:)Quote:
Originally Posted by mysybet
it has link to correct bios, your restarts cause by wrong ones.
Thank you !
But where is the install guide ?
http://www.hackint0sh.org/f152/96112.htmQuote:
Originally Posted by mysybet
everything you need is on there somewhere, just look thru the posts.
Thank you , but i try the bios settings but again the computer restart at setup begin.
But , if i disable the APCI APIC support ( in the guide that should be enable)
the setup begin , doesn't restart , i see the apple logo but the process halt here after some seconds and doesn't continue.
What Can i do ?
P.s I have installed in my Pc the Leopard 10.5.8 without any problem , but with snow leopard i have this situation.
are you using retail and empire efi?Quote:
Originally Posted by mysybet
as it is much better than distro disk.
i'm using Snow Leopard Universal 3.6 (10.6.2).
Distros are poo,Quote:
Originally Posted by mysybet
Use the retail install.
there are a lot of snow leopard dvd version on the internet. .Can you help me which should a take ?
buy the retail one;)Quote:
Originally Posted by mysybet