Iatkos v 7 won't boot past "loading Darwin /x86"
I've been looking around at all of the forums and can't seem to find an answer. Iatkos v 7 won't get into the installer. Whenever I run -v, it gets to the "loading Darwin /x86" and the spinner on the left eventually stops and goes away. Then it just sits there. I have tried these options (usually interchangeably): -v, -f, -x, toh -v, -v busratio=10 cpus=1. When I run nforce_core -v it goes back to the press f8 screen and when i type in -v, it gets stuck at "setting boot -uuid to: CA70EDFA-SC0F-3EE1-85C1-549AD20F9B35" then gets stuck again at the loading darwin screen. I have used the same .iso to install on my Dell and had minimal problems, so I know the .iso is good. Any suggestions?
Compaq Presario CQ60
AMD Athlon Dual-Core QL-62
HP F.54 BIOS
NVIDIA GeForce 8200M G 256MB
Atheros AR5007 802.11b/g WiFi Adapter
*Sorry, I didn't notice that I put this in the Snow Leopard Thread