Hello Hackint0sh! It's my first post here!

I searched for a while and couldn't find anything about my issue, so, here it is:


I've just downloaded iAtkos S3 V2, and burnt it to a DVD+RW (Maxwell) and when I try and boot it on my HP Pavilion dv6 3056-sa I get to the bootloader. When I press f8 (or anything) my laptop just freezes. If I wait until the progress bar empties fully, it freezes as well. If anyone can tell me what I'm doing wrong, I would be very thankful.

Am I using a bad type of disk? Is my hardware not supported? Is it just a bad ISO, and I'm not actually doing anything wrong (I doubt this, TPB comments all say it's fine)?

Thanks in advance,

Saam123

EDIT: Sorry for posting in the wrong section, I was linked here by a friend. Could it be moved to: http://www.hackint0sh.org/f213/