Good morning to one and all,

I have been trying to install on my Dell Inspiron 700m, with an Intel 1.8 processor an a couple of megs of ram. I have tried (in order of installation)

- Kalway 10.5.2 would not even boot after the first splash screen with the grey apple.

Jas 10.3 and 10.4 these installed complete but fail to boot up once i reboot it goes into a infinite loop on the boot screen.

IPC OSX86 leop[ard 10.5.6 gave me a disc error

Ideneb V1.3.10.5.5- Same as JAS

TOH 9a581 - Same as Jas

I have read and seen you tube videos until my eyes burn!

I know I'm doing something wrong but I cannot pinpoint it.

Can some Guru, Yoda Master, Compu osx86 sabi, master of the osx86 universe give me a hand?

Thanks in advance.

kalway works all you have to do is select options incustomise during install make sure the drivers are specific to dell dont select any of the graphics drivers the motherboard chipset shoule all be selected i think the most important part is acpi part all options should be selected there other drivers lan wlan audio are there wlan might not work if you u dont have the broadcom wireless everything should install fine
now reboot you should see the grey apple screen and depending on what your doing you could have different results for example on my 700m it takes 6 minutes for osx to load but at the same time my battery isnt working i read on the osx86 hcl that it works better when booted up pluged in i cant tell you that much till i have a battery i use it pluged in all the while prolly if you see the thing spining forever you checked the wrong options in customise if it spins then freezes the spin just give it like 5 minutes and it boots trust me