I am having some issues installing HAZARD 10.6.1 & 10.6.2 on my system. When I try to boot into osx installer it just restarts. I've tried boot flag after boot flag trying to get it to boot properly. I just can not seem to get it to work. I was thinking I need a different Kernel when trying to boot seeing if that would help.? If anybody has any suggestions or solutions I would be very grateful!

My System:
-AMD Phenom II X6 1045T 2.7GHz
-12GB DDR3 RAM
-Radeon HD 6870
-Chipset - AMD 870 / SB850
-Realtek RTL8111E - 10/100/1000 Controller
-Realtek ALC662 6-Channel HD Audio

At what exact point is it restarting?

Right before if it would go into verbose mode or the "Apple Logo".

Originally Posted by Rhand McCoy

Right before if it would go into verbose mode or the "Apple Logo".

I have this same issue, when booting with -x it shows that it panics on apci , have tried several things like modbin cd, bootflag apci=off etc

Ya and its not just Hazard its all of them from iatkos to retail. Nothing seems to work.

Leopard does boot from dvd though I can install it but it will not boot the installation.

Its just 10.6.1, try 10.6.4 dvd, and dont use amd, its not even meant to work, sorry, but it will just cause many probs

Use iAtkos S3 V2 or OS X INDO

for iatkos s3 v2 use busratio=18 cpu=1 UsekernelCache=No npci=0x3000 PCIRootUID=1 GraphicsEnabler=Yes -x -f -v

OS X INDO

mach_amd busratio=18 cpu=1 UsekernelCache=No npci=0x3000 PCIRootUID=1 GraphicsEnabler=Yes -x -f -v

see if that works for you..

The progress on this so far is iatkos s3 v2 is successfully installed. I boot with the following flags: -v busratio=20 -force64. Networking WORKS!! Having trouble get the graphics kexts for my Radeon HD6870 to work, they fail to load... I would love to get some help from the community to, get this system up and running 100%.