Discuss Can someone HELP ME!!! ...tad bit frustrated at the Installation - Hackint0sh.org; Failed again!
I have the 10.6 by A.K. and I tried installing with all the ...
I have the 10.6 by A.K. and I tried installing with all the kext's I think I needed
same thing as before...install finishes but wont boot just goes to a blank screen and makes my fan run extra hard.
Then I tried installing but going to an older version of Chameleon V3
Then I tried installing without customizing the install at all!
What do I dooooooo? Could it be my Bios? I have a HP Probook and the bios is fuct! It is all Branded
I have no Idea why this wouldnt work! You would think if the graphics and stuff work during the install that they should work after the install is done right?
and lets get this clear, I finish the Install to the point where it says
Installation Completed Successfully
Restart your computer
then Bamn nothing...black screen and my windows MBR is messed up again!
try Chameleon RC4 PC-EFI 10.6 ,works great on me, also ATI init for graphic, just to get it start , voodoHDA for sound. Just dont choose too much kexts for your hardware, because it will be easier to find out when it is not match your hardware. Also recommend to choose all System Patches (not sure about USB patch, but..). Also try using default mach kernel.
if you can , verify your installation and make sure it's active.
boot with -v -f (you can also add -x32 cpus =1 ).
Whats up everyone?
I burned a copy of Kalyway V8, and I have gotten further than any other attempt.
THe install completes, then I reboot then I got the white screen with the grey apple logo and the spinner at the bottom
its spins for a bit then it just hangs.
How long should I wait for this?
I waited like 3 minutes then I shut my computer down
Here is what I get when I Use EFI boot, and do the
-v -f command
And it just hangs here......
Last edited by EchoAfire; 11-14-2010 at 11:16 AM.
I got Kalyway to finally boot, But
- no wireless
- no sound.
And I did some research...looks like there are no Kexts for my ATI video card for my laptop.
I think I am going to give up trying to get it to work on my laptop.
I have a desktop I can put back together and I checked out the video card on it and there are kexts for it
now that I look at it...there are kexts for everything. Looks like I am putting this thing back together
Its sad but i seriously only want to Run OSX so I can use the new ilife 2011
By bap779 in forum Kernel / Kext (Driver) Support
Last Post: 05-02-2011, 03:53 AM
By Drawllimuk in forum Installation
Last Post: 02-05-2011, 05:39 PM
By shannonharvey in forum Installation
Last Post: 04-15-2010, 09:09 PM
By unclemiltie in forum General
Last Post: 08-26-2007, 08:58 PM