Results 1 to 4 of 4
Discuss AHCI problems? Read here! at the Installation - Hackint0sh.org; Hi, you most likely came here cause you have a problem with AHCI, either something ...
  1. #1
    sam
    sam is offline
    Chief of Administration
    iPhone Dev Team
    Array sam's Avatar

    Join Date
    Jun 2007
    Posts
    1,852
    Post Thanks / Like
    Downloads
    35
    Uploads
    277
    Rep Power
    10

    Default AHCI problems? Read here!

    Hi,

    you most likely came here cause you have a problem with AHCI, either something crashed, your disc wasn't recognized or something similar. Ok, the first problem is that OSX needs AHCI to work. AHCI stands for Advanced Host Controller Interface and is a open interface definition for SATA controllers.



    Since this is a very widely used thing, you will have an option in your Bios for this, sometimes it goes by names like SATA Configuration too. If you are unable to find it there and you see an option RAID instead, disable RAID in the Bios first and check if it appears.

    Good luck and happy Hackint0shing!
    If you just want to support hackint0sh.org with a donation click here.
    Follow me on twitter: http://twitter.com/sam_hackint0sh



  2. #2
    Newbie Array

    Join Date
    Jul 2012
    Posts
    3
    Post Thanks / Like
    Downloads
    0
    Uploads
    0
    Rep Power
    0

    Default

    stuck on the same issue but i dont see the option

  3. #3
    Newbie Array

    Join Date
    Aug 2012
    Posts
    2
    Post Thanks / Like
    Downloads
    0
    Uploads
    0
    Rep Power
    0

    Default

    Yes, i too have this issue where the osx installer dvd cannot be detected. I have gone through the CMOS Setup Utility on my ECS G41T-R3 motherboard and I see no option which allows me to set anything to AHCI mode. IT is sooo frustrating and I would really appreciate some help on this matter. BIOS is AMI.

  4. #4
    Newbie Array

    Join Date
    Sep 2012
    Posts
    6
    Post Thanks / Like
    Downloads
    0
    Uploads
    0
    Rep Power
    0

    Default

    The thing is that when I change to AHCI, my HDD doesnt not boot, after POST my screen goes black

 

 

Similar Threads

  1. Problems with P5K-SE/EPU and AHCI
    By holdon in forum Installation
    Replies: 0
    Last Post: 06-02-2011, 04:38 AM
  2. Replies: 1
    Last Post: 08-28-2009, 10:33 PM
  3. Replies: 8
    Last Post: 09-16-2008, 04:58 AM
  4. Problems receiving incoming calls? READ
    By Darkflame in forum General
    Replies: 3
    Last Post: 01-29-2008, 06:43 PM
  5. AHCI detection procedure? ICH8 AHCI annoyances
    By zulu.walker in forum Archiv (Leopard)
    Replies: 1
    Last Post: 10-22-2007, 02:25 PM

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  
Powered by vBulletin®
Copyright © 2014 vBulletin Solutions, Inc. All rights reserved.
Search Engine Friendly URLs by vBSEO
(c) 2006-2012 Hackint0sh.org
All times are GMT +2. The time now is 04:43 AM.
twitter, follow us!