Tiger works, but Leopard doesn't?
Ok, so I finally got OSX 10.4.6 Tiger to work on my PC. I am still unable to get Leopard to work though. What gives?
I used the JaS install DVD for my Tiger config and enabled:
10.4.6.Combo.Update = 747MB
Intel.SSE2 = 8.2MB
This install works great and I have sound, internet, etc...
Now, when I go to install Leopard, it's a different story.
I have tried both iDeneb 10.5.5 and iPC 10.5.6 with no luck. I can get a successful install with iDeneb, but not with iPC. However, when I go to boot it after installing iDeneb, it just goes into the loop (infinite) boot. Not sure what I'm doing wrong. What should I have enabled for my pc with these distros? The JaS disk was so simple. GAH. I want LEOPARD.
Dell Optiplex GX260
1.80 GHz P4 CPU
1GB DDR SDRAM
MMX, SSE, SSE2
AC97 onboard audio
82845G/GL/FE/PE/GV Onboard Graphics