Installation Succesfull but now can't load into leopard

Hi Can someone please help me with this please.

I have successfully installed without no problem, at the and of installation it says sucessfully installed please reboot computer!

Upon doing this and taking out the boot disk there is a static grey screen with the apple logo, nothing else, anyone got any ideas on how i can get leopard to load, it is on the hard drive but will not load. "I was so close!!!":confused:

Many thanks in advance to anyone who can help please.

Thanks,

Foxconnusa
I have the following system on my Intel Based PC:
Asus P5N7A-VM Motherboard
Nvidia Geforce 9300 Chipset (Built into Motherboard)
x64-based PC
Intel Core 2 quad CPU Q6600 @2.40Ghz, 2400 Mhz, 4 Cores, 4 Lo
Bios Version: American Megatrends Inc, 0404, 14.10.2008
SMBIOS Version: 2.5
Installed Physical Memory 8.00GB
Total Physical Memory: 4.0GB
Available Physical Memory 6.49GB
Total Virtual 16.0GB
Available Virtual Memory 14.5GB

(Hope This Helps!!!)

What distro are you trying to install? How did you customize? did you try to boot using one core? did you install with AHCI SATA Support?

Hi thanks for your reply, I am using kalyway 10.5.2

I am currrently in the customize section

I cant see the AHCI Support in there, any ideas?

I am also not sure what kernals to use, the only one ticked in the kernals is kernal_9.2_sleep

Many thanks,

Foxconnusa

Quote:

---

Originally Posted by icchansan

What distro are you trying to install? How did you customize? did you try to boot using one core? did you install with AHCI SATA Support?

---

The AHCI should be enable it on the BIOS, also enable XD BIT, with your processor you should install Vanilla Kernel

Thanks Icchansan, done that now, but now cant find XD Bit to enable in bios, any ideas? sorry to be a pain!

Foxconnusa

Quote:

---

Originally Posted by icchansan

The AHCI should be enable it on the BIOS, also enable XD BIT, with your processor you should install Vanilla Kernel

---

Sometimes its called Execute Disabled or NX Bit, have to be there around advanced options or Power Options :P

thanks for your help, much appreciated.

With regards to the Sata Drive im using IDE
its currently
looping on startup, can go into darwin and also can select Foreign OS but when I select it says
non-systen disk - press any key to reboot!!

Install was sucessfull though, please help.

Any ideas please?:confused:

Many thanks

Quote:

---

Originally Posted by icchansan

Sometimes its called Execute Disabled or NX Bit, have to be there around advanced options or Power Options :P

---

Ah I see, IDE... may sure its set as Master, and your DVD Drive as Slave, with the jumper not cable select, and if you can, put them in different ide cables and try again... if kalyway seems not to be working, try with another one.

Hi,

I am having exactly the same problem too, using Kalyway 10.5.2 distro. Installed using default options.
Here are my specs:

Intel E7200 Core2Duo Processor @ 2.53 Ghz
XFX nForce 6 motherboard
2 GB Kingston 800Mhz System RAM
160 GB Hitachi SATA HDD

I have enabled AHCI in BIOS, but still i cant get it to work. The hard disk drive is connected as 4th SATA.

This is my third install with no luck.

Any help is appreciated.

Thanks and Regards.

Whats the mobo chipset digineo?