iatkos v5 install problems
hello, I'm new here and have been surfing around on google finding the easiest way to install and run leopard on my laptop while keeping vista as well. The problem is I have dl'ed iatkos as well as ideneb but can't seem to get them to boot or even start to install when I reboot my laptop. I have an Asus x83vm laptop and have partitioned my C drive into a smaller section and have gone off of all tutorials and searches I can find, but nothing seems to get me past that stupid blinking cursor. And, that is the problem, everytime I put in the iatkos or ideneb disk and reboot, all i get is a blinking cursor. I couldn't find anything else that addresses this, because all my searches on this only lead me to "blinking cursor after install." Mine is before install. If I am not prepping my laptop right prior too install, please advise as I couldn't find anything about system prep (ex..bios, hdd, software needed) other than what I have and have done above.
Any help would be greatly appreciated.