Discuss OS X won't load after kalyway 10.5.2 to 10.5.6 update at the Installation - Hackint0sh.org; Hi.
I have a Toshiba Tecra A2 with the 80 GB HDD and a pentium ...
OS X won't load after kalyway 10.5.2 to 10.5.6 update
I have a Toshiba Tecra A2 with the 80 GB HDD and a pentium m 1.8 GHz processor.
I followed a guide i found on the internet on how to update kalyway from 10.5.2 to 10.5.6.
The one where you use universal installer and osx86tools.
The main update installation went well, and when i got to the darwin boot prompt, it showed it had installed the Chameleon bootloader (PLCIEFI V9), so i booted with the -f -v prompt.
It loads all kernels, but after loading the kexts and goes into booting the system up, it just comes up with a blank screen.
if i boot with -f, it loads the kexts, then comes up with the white apple screen, but there is no spinning circle thing under the apple.
It just freezes.
Could it be to do with installing pci efi v9?
BTW i am using Darwin 9.02 ToH Kalyway 10.5.2 before update.
Thanks in advance
Kalyway 10.5.2 on Toshiba tecra a2
Can you please post the process you used to install Kalyway 10.5.2 for your laptop?
By jp612 in forum Using Snow Leopard
Last Post: 02-06-2011, 05:41 AM
By tonbai in forum Installation
Last Post: 01-10-2010, 11:11 AM
By kolef in forum Archiv (Leopard)
Last Post: 09-03-2008, 12:45 PM
By kurle in forum PwnageTool
Last Post: 07-20-2008, 05:05 PM
By three30three in forum General
Last Post: 02-05-2008, 06:52 AM