Hey,

after solving some problems by looking up in this board I'm finally stuck installing MacOSX on my laptop.

My specs:
Thinkpad T61
Intel Core 2 Duo T7250
2GB Ram
Intel GMA 3100

My HDD setup:
One internal S-ATA Disk, where Win Vista installed
One IDE-Disk in my Ultraybay, where I installed Mac OS

I tried iDeneb v1.3, Leo4All v3, iATKOS 4.1i but none of them bootet: either "waiting for root device" or something else occured during first boot. Installation always went without errors.

So finally I installed JaS 10.5.4 and it worked. When booting, I have to plug in a USB-keyboard. So I did and continued the setup assistant. But when asked "Do You Already Own a Mac?" it gives me trouble. Half a minute nothing happens, then the cursor gets "waiting" and then the whole assistant restarts beginning with the 3D-fly-through-space-video. To clarify: I check the option that I don't want to use the assistant right now.

Any ideas how to get past this?

Thanks for your help, I highlighted the important parts for better understanding.
- shanokee

btw: I can boot in single user mode.

Hi,

i have the same issue here. Running LeoV3 on a HP Pavillion 6810.
Crashlog says:

Exception Type: EXC_BAD_ACCESS (SIGBUS)
Exception Codes: KERN_PROTECTION_FAILURE at 0x00000000000000
Crashed Thread 0

<and then follows to much data to simply type>

Did you or anyone else find a solution to this?

If you both have the same issue check the FAQ in my signature, and you'll see the solution for this loop

that does the trick, thanks a lot!
now to get wifi up&running

If you need to get wifi working have to tell us your chipset

didn't really think that belonged in this thread, but ok. It's an Atheros RA5007 wifi card (mPCI). I've tried installing a patched kext and running kismac (doesn't work) and installing the orangeware driver (doesn't support x86).

The card is detected using the patched kext, but it cannot find any networks (even using kismac to put it in passive it still doesn't find anything).