I'm trying to install 10.5.6 / 10.5.7 on My HP Pavilion dv9000 (dv9608nr) laptop.

Everything loads fine, go to Hard drive utility and it sees nothing. It did this on iDeneb and iAktos. So I don't know how to proceed with this problem. I can post specs if you guys want.

Please post your full specs, did you try to boot in force mode?

how do I do that >.>

also specs are

AMD Turion 64 X2 TL-58 1.9Ghz (200x9.5)
Quanta 30D1 Motherboard with nForce 560 chipset
Bios F32
4GB of OCZ DDR2, 667mhz 4-5-5-15 2T
Geforce 7150M/nForce 630m
160gb Toshiba MK1652GSX SATA
Network - Broadcom 802.11g & Nforce controler
HDAudo Soft Data Modem
DVD-Burner - HL-DL-ST DVDRAM GSA-T20L ATA
Audio - Conexant HD SmartAudio HD2

Not really sure if this system is compatible but lets try, boot into your dvd, wait for darwin and press F8, then type:

cpus=1 -v -x

if it doesnt work try with

rd= This parameter state what is the boot disk to use (instead of using the boot menu appearing before the prompt) you state the drive and partition in here: diskXsY where X stands for the disk number (first disk, usually primary master in IDE or SATA) 0 second disk is 1 etc.) and Y stands for the partition on that disk starting with 1 as the first partition.

Ex: rd=disk0s1 If you have one disk and one partition the parameter will look like this.

Tried that, That didn't work. It doesn't see the hard drive at all. I checked it under System info too.

sorry to bump the thread but I still need help.

Well I'm pretty sure it's the SATA Drivers. Due to the nForce 560/630 chipset on this board. If anybody could help me fix this, I would be very grateful.