When trying to install Kalyway onto my desktop, it always freezes at the welcome screen. It says something about welcome to Kalyway for amd/intel, but I cannot click on continue or back.

I've tried installing with leo4all, which will install but the graphics drivers will not work. I read that Kalyway worked better with my card so am trying that instead.

Spec:

Gigabye K8NXP-9 mobo, AMD 3800+, nvidia gefore 6600GT 128mb.

I have an M-audio soundcard, ethernet card and external drive connected as well.

Install leo4all and install your video driver post installation, you can install your audio and LAN post installation too but you have to tell us the chipsets

Sound promising, but how do I install the drivers post-install? I had a look on the nvidia website, but not surprisingly they only had drivers for windows or linux.

Chipset is nforce 4 ultra.

LMAO you wont get any help there, check this thread, and you will get QE/CI

Can you install everest to get your LAN And Audio Chipset model?

Ok, well I've done a fair bit of experimenting with graphics drivers, but still haven't got to be able to use a higher resolution.

I've copied all the NVDANV*.kext, the NVDAResman.kext files and the NVinject.kext file. Edited them with my device ID and set the permissions as according to http://nvinject.free.fr/forums/viewtopic.php?t=4.

It even says in system profiler under display: 'ROM Revision: NVinject 0.2.1', but still can't change res and it says 'Quartz Extreme: Not Supported'.

Is there anything I could have missed?

My LAN and audio actually works fine without installing drivers at osx install, so probably don't need to do anything to them.

Ok, I tried using nvinjectgo instead and I now can boot into safe mode with high resolution! But if I boot into normal mode, I get a blank screen after the apple logo and eventually just a spinning beachball. The beachball appears to be in high resolution mind..

Any suggestions to help fix this?