Discuss CPU Multiplier "0" Issue when trying to boot at the Installation - Hackint0sh.org; UPDATE:
So after installing iDeneb I basically ran into the same problem again, the computer ...
CPU Multiplier "0" Issue when trying to boot
So after installing iDeneb I basically ran into the same problem again, the computer would not boot, it would just restart. What I found was that you have to do this:
"At Darwin Bootloader, press f8, type: busratio=20 "
Hopefully this saves someone else some time...
I got the iDeneb release and it was able to install. I would prefer the retail disc, so I'll work on that after I get this one running smoothly. If anyone has any suggestions I welcome them
I keep getting the "Determined CPU/FSB multiplier to be 0 - CPU says it's multiplier is 0 which makes no sense." issue when trying to boot(install) either a retail copy of Leopard (using grub-dfe.iso to boot) or the iPC release.
I've been looking everywhere for a solution but everyone seems to say the same thing: "click yes to continue".
However, when I do that my computer just restarts...
Anyone else have this problem?
My system is:
Intel core i7 920
6gb DDR3 Corsair
Sata DVD RW
Last edited by reinehc; 05-02-2009 at 01:26 AM.
By pipetkin in forum Free Toolchain Software (Cydia App's)
Last Post: 08-18-2008, 04:29 PM
By jashsayani in forum Archiv (Leopard)
Last Post: 05-06-2008, 01:56 PM
By max9241 in forum iPhone "2G" (Rev. 1)
Last Post: 11-11-2007, 04:12 PM
By glen.tw in forum General
Last Post: 10-25-2007, 05:25 PM
By atresso in forum General
Last Post: 09-15-2007, 09:15 PM