[1.1.2 OTB] HW unlock - worked fine but then a problem with anysim
This is my 3rd 1.1.2 hardware unlock. the first 2 were very smoothly unlocked and worked perfectly.
My problem with this one is that after i succeeded with the hardware test point, i tried to execute anysim on my now 04.01.13G / 1.1.1 device. I had the "succefull" message from anysim but the cellular carrier signal indicator is not showing any signal. WIFI, bluetooth are working. My modem firmware is 04.01.03G and the CCID number is present in "setting/General".
Is it possible that i damaged the thin wire on the board while i was connecting the test points with the needle? or if it was damaged the WIFI also shouldn't be working? Because as i mentioned above the wifi is still working.
it would be really appreciated if somebody can answer me.
Thanks a lot.
I found what was wrong and it worked. Thanks anyway. I will write it bellow soon for people with the same problem as mine. Right now i am assembling my iPhone.