history of my iPhone 2G 8GB:
1.1.2 - 04.02.13_G - geohot testpoint (sold)
1.1.2 - 04.02.13_G - ziphone
1.1.3 - 04.03.13_G - dev-team cydia update
1.1.4 - 04.04.05_G - iLiberty+
2.0.1 - 04.05.04_G - winpwn
2.0.2 - 04.05.04_G - winpwn
2.1 - 04.05.04_G - quickpwn
2.2. - 04.05.04_G - quickpwn
2.2.1 - 04.05.04_G - quickpwn
3.0 - 04.05.04_G - redsn0w
3.1.2 - 04.05.04_G - blackra1n
3.1.3 - 04.05.04_G - redsn0w
Can someone help me find information on the "original" dev team and the elite team? Not information on them but new info from them.
This is down? It was up a couple of days ago. Anyone know what's the deal?
These cats have no new news. Must be busy.
Where can one get updated info from them...if available.
Found the elite folks...
Good for them!!
Last edited by ajaikarran; 01-19-2008 at 09:33 AM.
if you get disconnected while ienew'ing, whatever you do
use ibrickr to install mobileterminal and finish the downgrade from there.
Otherwise you will be with a un-jailbreakable, wifi-less, brick.
void unlock(int& Iphone)
"could not enable ssl"..
running out of hope.. anyone?
what will hapen if i'll restart and then finish the downgrade?
Hi there. I'm about to try this. But in many replies is said, you need to solder.. But as given in the startpost:
does not mention it in any way.. So, what was that all about?
The needle method is a slightly simpler alternative to soldering. The point is, that line A17 needs to be connected to a voltage source.