Discuss My USB ports are not working at the Hardware - Hackint0sh.org; I currently have Snow Leopard 10.6.8 installed.
usb 1.0 devices seem to work fine on ...
My USB ports are not working
I currently have Snow Leopard 10.6.8 installed.
usb 1.0 devices seem to work fine on my usb 2.0 ports, but usb 2.0 devices wont even show up.
On boot up i get EHCI errors for my USB 2.0 devices and USB Mass storage devices.
the EHCI errors say something about could not get chip to halt within 100ms
my wifi card is usb 2.0 so i dont have wifi
i am too ineksperienced to patch the DSDT file.
i have a motherboard that is apparently unknown to everest.
I have MCP78 northbridge chipset. AMD K10 southbridge
My computer is an Acer Aspire Z5101 (if that helps)
AMD Phenom ii times 4 905e
6gb ddr3 ram
1tb hard drive
ati hd 5570
boot flags -force64 arch=i386
i used the DSDT patcher GUI to make my dsdt.
i have everything working ecept for the usb 2.0 devices
if anyone can help me please reply and tell me what more you need to know.
thank you! biggrin.gif
Chief of Administration
iPhone Dev Team
Any indication in your system.log what is goign wrong? Can you post a kextstat?
By Skunk007 in forum Using Snow Leopard
Last Post: 08-21-2011, 07:23 PM
By redbearwa in forum Installation
Last Post: 06-19-2011, 03:32 AM
By hawks18305 in forum Kernel / Kext (Driver) Support
Last Post: 11-25-2010, 12:31 PM
By Woolf in forum Using Leopard
Last Post: 03-20-2009, 09:12 PM
By theviolator in forum General
Last Post: 03-19-2008, 06:54 AM