[Touchscreen] Bottom not responsive after Hardware Unlock

**geselaw** · 06-07-2008 09:49 PM

Sorry for kidnapping your post but I have the same problem with my iphone so I used the new winpwn to restore my bootloader to 4.9. but my problem is after restoring to 1.14 using itune my phone still works with t mobile. any suggestion?

**dtube** · 06-08-2008 12:46 AM

your phone still works with tmobile .... so what is the problem ?.
Yeah, hijacking a post just make it more confusing. Why don't you start a new post and explain your problem and question .

**geselaw** · 06-11-2008 08:40 PM

My problem is half of my screen digitizer is not working. I am trying to return my phone to Apple. That is why I was trying to restore it to factory mode with winpwn because I can not use bootnuter (because of my screen). After using winpwn my phone seems to be in the original state, not activated, but as soon as I put the t-mobile sim, it connects to tmobile. because of this I could not return my phone.
Please help.

**dtube** · 06-11-2008 10:51 PM

Hum .... this is a tricky one ....

the reason your iphone is unlocked because your customize ipsw image has the unlock checked in bootneuter. You may want to create another image without the unlock check mark and use that to restore the phone.
You may want to have neuter off as well.
And remove bootneuter afterward ...

**geselaw** · 06-13-2008 12:07 AM

I did not check the unlock on winpwn. I only upgraded my bootloader to 4.6 .I have tried different setting but to no avail .

I used hard ware unlock in the beginning because there was no software unlock at that the time. Then I used ZiPhone to unlock my phone. That is why I tried to restore
my bootloader to 4.6.

**Muaitai** · 06-14-2008 05:10 PM

You did a hardware unlock and half of your screen digitizer is not working? I think the problem might be there.

**crispain** · 06-16-2008 10:46 PM

Originally Posted by Muaitai

You did a hardware unlock and half of your screen digitizer is not working? I think the problem might be there.

I don't think so. To hardware unlocking you don't need to remove the boards and unpluging the screen.

You may try to downgrade to 1.0.2, or 1.1.1, or 1.1.2, activate & jailbreak.
Then using ibrickr or iphone pc suite install bsdsubsystem and openSSH.
If you are able to reach to setting > wi-fi and see the IP provided by the router, you're done.

The next step is downgrade the firmware using the proper secpack and finally restore to the firmware version you want.