[Bluetooth] Iphone 1.1.4 and Audi bluetooth car kit volume problem!

I have a problem with my Audi RNS-E (SW 650) bluetooth car kit and iPhone 1.1.4:

volume on incoming call...too loud
volume when dialing/conversation is set way too high
disconnect blings are very loud

I can set the volume down on the iPhone or the RNS-E but it will not stored. The next incoming call/conversation volume will be extremly loud again and the bluetooth volume on the iPhone is set too high.

just wondering if this is an issue with everyone or just myself.
i've searched in other forums and found a few topics on the issue, but there
are no fixes that i know of either.

Does anyone have the same issues?

Tanks in advance!

I have an Audi 08 A4 and bluetooth but a Sony Ericsson phone with the same problem with the high volume, esp. when ending a call. I am sorry I don't have an answer, but want to mention that it doesn't seem to be your phone but rather the bluetooth.

I think I figured it out...the volume on the steering wheel control isn't the one that sets the phone volume. Try using the volume knob on the radio and turn it down a little more than you normally would before a call comes in. I think this is the one that controls the disconnect sound, which is what my main problem was with the bluetooth.

I hope that helps!
Leslie

i have the opposite problem that mine is too quiet even when i put the volume on my phone and car all the way up. i can hear people but barely. any ideas? it's an 08 A4