I accedently dropped my iPhone which shattered the front glass. Fortunally the iPhone it self did still work so I decided to order a new front panel to install. When it arrived I disassembled my iPhone by doing the following:
1) remove the two screws
2) using a suction cup for the glass
3) Removed the cables: 1, 2 and 3
4) removed the screen (6 screws)
5) hair dryer for getting the front panel off
The problem is that when I assembled it again it won't turn on. I tried a few times placing the 3 cables again (especially the third cable which is hard to slide in; yet i think that is for the speaker this cable shouldn't afflict the whole iPhone?).
Notice that I disassembled it before without step 5 (didn't have a hair dryer) before where it still worked when I assembled it.
Currently the iPhone won't turn on, I can't seem to reset it and it does not respond on getting plugged into the computer.
Any advice would be appreciated!
I got it turned on now, tried to work the cables out; however, everything works except the top speaker? Is that cable nr. 3?