iAtkos ML2 10.8.3 to 10.8.3 * ATI Graphics Card 7870 Issue : ga-g31m-s2l
Hi Hackintosh, need some assistance not sure if anyone else has the same hardware type as per below:
Motherboard : ga-g31m-s2l
Bios : F9
Graphics Card: ATI 7870
CPU : Core 2 Duo
I've run into a situation, i've succesfully installed iAtkos ML2 10.8.2, and combo upgraded to 10.8.3, for ATI Graphics Card Support, but i have an issue upon booting into ML, does not load; or goes into white screen. I've managed figure out a work around by enabling the onboard vga via bios settings and selected it as main and always enabled on, plug in the vga cable into the second source on my monitor along side it with the ati dvi cable, turn on my computer and source is set to vga before ML boots in; i type "GraphicsEnabler=off" and it loads correctly but through vga source only. After i notice the login screen displayed in low resolution, i then change source from the monitor to the dvi and everything is full high resolution as it should be, checked system properties and noticed the ATI 7870 is enabled and recognised as the main graphics card. Can anyone explain to me why bootloader does not recognise the ATI 7870 only until im already on the login screen under vga for ML 10.8.3 ? its really buggin me having to switch source modes when turning on the computer.