Discuss unbrick iPhone (no sound) at the General - Hackint0sh.org; ...
unbrick iPhone (no sound)
just followed this article: http://www.djjeffa.com/vb/showthread.php?p=100869
because I have no sound at all
but got the following message during the procedure:
# bbupdater -e ICE03.14.08_G.eep
Preparing to flash using /dev/tty.baseband at 750000 baud
Please reset target
ProcessDetailUpdated: Boot-loader is active
ProcessDetailUpdated: EBL version: 3.9_M3S2 3..9
ProcessDetailUpdated: Boot mode is: CC
ProcessDetailUpdated: Baud rate set to 750000
ProcessDetailUpdated: Get flash id.
ProcessDetailUpdated: CFI stage 1
ProcessDetailUpdated: Flash ID is: 88620089
ProcessDetailUpdated: CFI stage 2
ProcessDetailUpdated: Boot process finished
ProcessOutlineUpdated: Reading SW version data
Error: couldn't retrieve version information: File not found.
Upgrade from ð
ProcessOutlineUpdated: Start downloading from file ICE03.14.08_G.eep.
ProcessDetailUpdated: Sending sec-pack.
ProcessDetailUpdated: Load region 0
ProcessDetailUpdated: Sending end-pack.
ProcessDetailUpdated: Checksum OK.
ProcessDetailUpdated: Verify OK
ProcessOutlineUpdated: Process time was 1695 msec.
what to do?
any help highly appreciated
try to flash the fls thats what is missing in the error
bbupdate -f ICE03.14.08_G.fls
don't forget to unload the commcenter and reload afterwards
By DRLCGA in forum iOS 4.x (iPhone OS 4.x)
Last Post: 07-11-2011, 09:59 AM
By Andrea_P in forum Hardware
Last Post: 02-11-2008, 10:10 PM
By freshpl in forum iPhone "2G" (Rev. 1)
Last Post: 12-30-2007, 06:46 PM
By jesse- in forum iPhone "2G" (Rev. 1)
Last Post: 10-17-2007, 07:46 PM
By jesse- in forum General
Last Post: 10-17-2007, 07:45 PM