Discuss Repair Needed!!! error 1011 at the General - Hackint0sh.org; I unlock my iphone by iUnlock, but in minicom process the first command "AT+CLCK="PN",0,"00000000"" give ...
Repair Needed!!! error 1011
I unlock my iphone by iUnlock, but in minicom process the first command "AT+CLCK="PN",0,"00000000"" give me ERROR, i try many times but nothing, so i ignore and write the second line and gime me OK. I put my SIM (Claro) and working. Two weeks after the iphone show me "no service", i try with other SIM (TIM) and work, i change the SIM again and "no service", so i go to settings and click in carrier, sometimes show me one network, sometimes other. I restore the phone and run iUnlock again, the "no service" persist, but now with the other SIM too, i click in carrier and now show a ERROR. I flash de baseband and run anySIM 1.1, now the phone show me a message "Repair Needed. iPhone cannot make or receiver calls.
I try flash the baseband again, but show me a error that other app is in using.
When i try restore, error 1011.
I lost my firmware and bootloader on 1.0.2 firmware.
What i do???
someone had luck getting out of a 1011 error by doing the following
ok i went in iBrickr let it restore.
it did some sort of test where my screen went all Green.
it told me to restore with iTunes.. I did
i restored to 1.1.1 (well tried)
it failed again with error 1011.
i went back in ibrickr.
it did the same test and the screen went RED so i used ibrickr to restore
it downloaded and then did some test to make the screen all white.
then activation screen came on. iBrickr instructed me to retore again from itunes, but it will not recognize my SIM (Tmobile)
so i'm gonna dig up the original sim that came witht he phone and try to restore, to see if it works.
Ok on that activation screen that I was at
I ran paycay for 1.02
i don't know if that did anything but it loaded alot of stuff.
then i went in ibrickr and it did all the test again.
then i went in itunes again and tried to restore with 1.02 which i foun in ibrickr folder and i was able to succesfully load FW and SW for 1.02
no more comm error 1011.
Now I am at 1.02fw again
nope.. doesn't fix anything
Originally Posted by gaz919
I think i have a hard-lock, cause i got ERROR in minicom many times.
Someone know about it?
For sure it will not fix the problem its happens because of corrupt bootloader
Originally Posted by gaz919
i m having the same problem
use bootloader files to flash the bootloader if u hav teh luck than u maybe able to flash them otherwise no solution yet :-(
By sadeq_79 in forum Quickpwn
Last Post: 10-07-2008, 05:07 AM
By tonyxu in forum iPhone "2G" (Rev. 1)
Last Post: 07-01-2008, 09:24 PM
By JSN1 in forum iPhone "2G" (Rev. 1)
Last Post: 06-16-2008, 06:29 AM
By Amilar in forum iPhone "2G" (Rev. 1)
Last Post: 03-10-2008, 09:08 PM
By rgm in forum iPhone "2G" (Rev. 1)
Last Post: 12-22-2007, 12:18 AM